PLEASE SEE THE ATTACHED FILE
F’c = 4000 psi, NW conc.
Fy = 60,000 psi
SDL = 30 psf
LL = 50 psf
Slab S-1 and S-2 = 6”
1. Design B-1 for bending and shear at points F and G. Assume 14” wide beam. For bending use
#7, #8 or #9 bars only. For shear design, use the required spacing at critical section along the
entire span. Use #3 stirrups.
2. Design the column at G. Assume height is 16’ and loads are as follows, PD = 350 K, PL = 250 K,
MD = 40 K-ft and ML = 30 K-ft. Use a 14” minimum or larger column. Make sure that column is not
slender. Or in other words, make sure the column is short as part of a braced, non-sway frame.